Pressure washing that doesn't wreck the surface.
Driveways, walkways, patios, steps, brick and pavers. We match the pressure and the tool to the surface, so joints, finishes and wood don't get damaged.
$0.40 per sq ft · $150 minimum- 5.0 on Google
- Fully insured
- Free estimates
What we wash
- Concrete driveways and walkways
- Patios and front steps
- Brick, flagstone and pavers (with joint care)
- Decks and fences (gentle wash for wood)
- Oil, algae, moss and grime
- Rinse-down of everything around the work area
How it works
Measure and quote
Priced by the square foot, one round number for the whole job.
Right pressure, right tool
Surface cleaner for flat concrete, lower pressure for brick, pavers and wood.
Rinse and walk it
We rinse everything down and walk it with you before we leave.
Our own work. No stock photos.
Pressure Washing FAQ
How much does pressure washing cost in Marin?
Flat concrete is $0.40 per square foot with a $150 minimum. Brick runs $0.40 to $0.50, and flagstone and pavers cost a bit more because the joints need extra care.
Will pressure washing damage my pavers or brick?
Not the way we do it. We drop the pressure and use the right tip for brick and pavers so we don't blow out the joints.
Do you wash decks and fences?
Yes. Wood gets a gentle low-pressure wash so it doesn't splinter or fuzz. We clean only; we don't stain or seal.
Can you get oil stains out?
We can lighten most oil stains a lot. Old, deep stains may not come out completely, and we'll tell you up front.
Do you need water and power?
Just an outdoor spigot. We bring everything else.
Make it look new again.
Free estimates, usually same day. Gavin quotes it, Joey and Elijah run the crew — look for the wrapped G&J van. Bundle services and we'll give you one round number.
